WONDEC can configure the WT2850 TPE automatic insulating glass production line with a post-wash vision inspection station for manufacturers seeking more consistent surface-quality control before downstream assembly.
A Quality-Control Stage After Washing
The vision inspection station is positioned after glass washing and drying. It provides a defined quality-control point before the glass enters the downstream TPE insulating-glass assembly process.
By reviewing glass surface condition at this stage, manufacturers can make earlier quality decisions and avoid sending identified defective sheets into subsequent production steps.
Configured for Defined Surface Defects
According to the agreed inspection recipe, glass type and quality standard, the system can be configured to identify defined surface defects such as bubbles, stones, scratches, coating-related defects and surface contamination.
The final inspection scope should be matched to the customer’s glass thickness, coating type, target defect definition, production speed and acceptance criteria.
Inspection Results for Production Decisions
Inspection results can include defect type, size and location. Configurable judgement rules can support practical OK, NG or rework decisions according to the project’s agreed production logic.
Where required and technically confirmed, inspection information can also be prepared for connection with agreed downstream equipment or factory-management interfaces.
WT2850 TPE Line Configuration
The WT2850 TPE line is designed for warm-edge insulating glass production. The post-wash vision inspection station is available as a project-based configuration for manufacturers that require an additional surface-quality control stage within their insulating-glass workflow.
Configuration should be confirmed before order finalization to ensure compatibility with the required glass size, thickness range, line speed, inspection standard and downstream handling method.
Discuss Your Vision Inspection Requirement
To review a suitable WT2850 TPE configuration, please share your glass size range, thickness, coating type, target defects, expected production speed and preferred quality-handling method.